Atlona Help Center

KB01578 – Pin-out for IR pass-through using the AT-HDR/UHD-EX-100CEA-KIT

SKU: AT-HDR-EX-100CEA-KIT, AT-UHD-EX-100CEA-KIT

Question: What is the correct pin-out for IR pass-through when using the AT-HDR-EX-100CEA-KIT or AT-UHD-EX-100CEA-KIT?

Answer:

When passing IR from the EX-100CEA-RX to the EX-100CEA-TX:

1) Connect the compatible IR receiver (AT-IR-CS-RX) to the ⏚, RX, and P pin(s) of the EX-100CEA-RX.

⏚ = Ground, RX = Signal, P = Power.

2019-03-20_08h12_08.png

EX-100CEA-RX_-_IR_IN.png

 

2) Connect the compatible IR emitter (AT-IR-CS-TX) to the ⏚, and TX pin(s) of the EX-100CEA-TX.

⏚ = Ground, TX = Signal.

2019-03-20_08h14_48.png

EX-100CEA-TX_-IR_OUT.png

 

When passing IR from the EX-100CEA-TX to the EX-100CEA-RX:

1) Connect a control system to the ⏚, and RX pin(s) of the EX-100CEA-TX. Note: the EX-100CEA-TX will not supply power to the AT-IR-CS-RX. If an IR receiver (AT-IR-CS-RX) is to be used with the EX-100CEA-TX, it must be powered separately. 

⏚ = Ground, RX = Signal.

EX-100CEA-TX-_IR_IN.png

 

2) Connect the compatible IR emitter (AT-IR-CS-TX) to the ⏚, and TX pin(s) of the EX-100CEA-RX.

⏚ = Ground, TX = Signal.

2019-03-20_08h14_48.png

EX-100CEA-RX_-_IR_OUT.png

 

 

 Article ID: KB01578

 

 

 

 

 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Contact Us