KB01368 - How to enable control of an NEC M283X projector using the HDVS-150 system.

SKU: AT-HDVS-150-RX, AT-HDVS-150-TX, AT-HDVS-150-TX-WP

Subject: Unable to control NEC M283X projector using the HDVS-150 system.

Solution:

To set up RS232 control of an NEC M283X projector using the HDVS-150 system, please follow the steps below:

1. Open the HDVS-150 control software, for help with this process please see this article.
2. Reference projector Mode
3. Address connection Info
   1. Baud rate 38400, Data 8 Bits, No Parity, Stop Bit 1.
4. Input code as Hex with no letters or delimiter.
   1. 02 00 00 00 00 02 = Projector On command
   2. 02 01 00 00 00 03 = Projector Off command

The software should show this:

The same commands should also work for most other NEC branded projectors.

Article ID: KB01368