Atlona Help Center

KB01017 - HDVS Supported HDMI Audio Formats


The AT-HDVS system will pass through 2ch audio from an HDMI source to the HDMI output of the HDVS-RX. The analog audio output will also pass 2ch. 

You do not have to enable/disable any functions in the RX to perform this function. Simply connect your audio/video source to the TX which will automatically pass the video/audio signal through to the RX.

If you want to utilize the analog audio breakout of the RX, please note this will not downmix audio signals but will only de-embed them. This means that sending a Dolby signal in will not produce a stereo signal out. You must set your source to output 2ch audio (such as 2ch PCM) which will then be de-embedded (stripped out) on the analog L/R output of the RX.

If you require the ability to pass multi-channel audio from your sources please use the AT-HDVS-200-TX-WP, AT-HDVS-200-TX and AT-HDVS-200-RX which do have the ability to pass multi-channel audio through the HDMI output of the 200-RX. The analog audio output of the HDVS-200 is limited to 2ch. 

Article ID: KB01017 


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Contact Us