Atlona Help Center

KB01019 - HDVS Supported Digital Audio Format FAQ


Scenario: I would like to pass a digital audio signal into my AT-HDVS-TX (via HDMI input) and then have the HDMI output of the AT-HDVS-RX pass that digital audio into the AVR that is connected to the output of the HDVS-RX, will I need to do anything to the analog audio output on the RX (such as turning it off) to enable this feature?

Solution: The AT-HDVS system will pass through the following formats from the HDMI input of the TX to the HDMI output of the RX:  PCM 2Ch

You do not have to enable/disable any functions in the RX to perform this function. Simply connect your audio/video source to the TX which will automatically pass the video/audio signal through to the RX.

If you want to utilize the analog audio breakout of the RX, please note this will not downmix audio signals but will only de-embedd them. This means that sending a Dolby signal in will not produce a stereo signal out. You must set your source to output 2ch audio (such as 2ch PCM) which will then be de-embedded (stripped out) on the analog L/R output of the RX.

Article ID: KB01019


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Contact Us