SKU: AT-ANC-108D
Description: How to Factory default an AT-ANC-108D
Troubleshooting:
- Remove the plate cover from the front of the wall plate
- Look for the reset button on the lower right-hand side of the unit (when looking at the front of the wall-plate)
- Press and hold the upper right button while using a paper clip to press and hold the reset button down (wait for the upper right hand button to flash twice)
- Next, pull the CAT cable out of the back of the unit for 20 seconds and then re-apply for power
Please Note: If you are using the power supply to power the wall plate please pull the power cable after the reset takes place.
The Factory default is complete and the device is ready to integrate into your system