SKU: AT-UHD-HDVS-300-KIT
The default setting for USB Host switching on the AT-UHD-HDVS-300-KIT is to follow the active video input. Below are instructions for how to change USB host switching:
Note: Follow video input will select the corresponding USB Host:
- USB Host 1 will follow HDMI 1 (Input 1)
- USB Host 2 will follow HDMI 2, VGA, and DisplayPort (Inputs 2, 3, and 4)
- USB Host 3 will follow HDMI RX (Input 5)
Switching between the (3) USB hosts can also be done via TCP/IP commands, AMS, or the WebGUI.
To manually switch between the (3) USB Hosts via TCP/IP:
- Connect to the AT-UHD-HDVS-300-KIT via Telnet. (Please see this article for reference)
- Send the USBHost command to switch from USB Host 1-3, or to set the unit to Follow the active Video Input
To manually switch between the (3) USB Hosts via the WebGUI:
- Connect to the AT-UHD-HDVS-300-KIT via the WebGUI (Please see this article for reference)
- Navigate to the “Settings” Page
- Under “USB Host”, uncheck “Follow video input” and select the USB Host port that you would like to activate
Article ID: KB01056