SKU: AT-HDVS-200-RX
Subject: How to update firmware on the AT-HDVS-200-RX
This unit can be updated through web GUI and USB.
‐ Needed items (web GUI):
‐ Latest Firmware
‐ IP address of the unit
‐ Computer on the same network as the unit
‐ Username and password to access the webGUI of the unit
‐ Unit and power supply
WEB GUI
1. Plug a LAN cable into the unit and your network router (if not already connected to the network)
2. Type the IP address of the switcher into a web browser (as seen below)
A login screen will appear (this is the same login for admin and general users).
3. Login using the username and password (this would have been set up during installation)
Once logged in:
4. Select the link named ‘System’
5. Select the Choose File button under Firmware Update
6. Select the new firmware file that was downloaded either from atlona.com or box.com
7. Press the Update button
A progress bar will display as the update is completed. After the update is complete, if a restart is required the required, the webGUI will display a prompt. The firmware update is now complete and the unit is ready to be used.
USB
‐ Needed items:
‐ Latest Firmware
‐ Mini USB to USB A cable
‐ Computer with a USB port
‐ Unit and power supply
1. Disconnect power from the unit
2. Press and hold the MENU button
3. While holding the MENU button, reconnect the power supply to the unit. Continue holding the MENU button for approximately five seconds, then release it.
4. Connect a mini-USB type-B to USB type-A type cable from the FW port on the HDVS-200 to a USB port on the computer which contains the firmware file
5. If the AutoPlay dialog is displayed, then click the “Open folder to view files” option.
6. Remove any existing firmware files in the folder
7. Drag and drop the firmware (*.bin) file into the folder
8. Disconnect the USB cable from the HDVS-200 and the computer
9. Power-cycle the HDVS-200 by disconnecting and reconnecting the power
The update process is complete and the unit is ready to be used
Article ID: KB01155