SKU: AT-HDVS-150-RX, AT-HDVS-150-TX, AT-HDVS-150-TX-WP
Subject: Unable to control NEC M283X projector using the HDVS-150 system.
To set up RS232 control of an NEC M283X projector using the HDVS-150 system, please follow the steps below:
- Open the HDVS-150 control software, for help with this process please see this article.
- Reference projector Mode
- Address connection Info
- Baud rate 38400, Data 8 Bits, No Parity, Stop Bit 1.
- Input code as Hex with no letters or delimiter.
- 02 00 00 00 00 02 = Projector On command
- 02 01 00 00 00 03 = Projector Off command
The software should show this:
The same commands should also work for most other NEC branded projectors.
Article ID: KB01368